3D Workspace
Home
Assets
Affiliate Program
Sign up/Log in
?
Upgrade
DCC Bridge
Anonymous1749850618
04-12 18:00
Model Name
onewheel gt dock 3d model
Tags
3d printing
3d printing realistic
props
props 3d printing
props 3d printing realistic
props realistic
realistic
tripo
Prompt
🖨️ Tripo AI Prompt — Onewheel GT Roll-In Charging Dock (3D Print) Design a 3D printable roll-in floor dock for the Onewheel GT. The object is a single low-profile horizontal cradle that sits flat on the ground. It has a central longitudinal wheel channel groove running front to back, approximately 7 inches wide and 2 inches deep, sized to capture the Onewheel GT's 11.5-inch diameter center wheel and hold the board upright and stable. On each side of the wheel channel are two flat horizontal rail support ledges, each about 2 inches wide, that the aluminum rails of the board rest on. The front of the dock has a smooth angled entry ramp at about 15 degrees so the wheel rolls in easily. The rear has a raised rubber-style bumper wall about 2 inches tall to stop the board. On the right side ledge near the rear, there is a small integrated rectangular clip/cradle sized to hold the Onewheel GT charging plug upright and ready to go
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
Anonymous1749850618
Anonymous1749850618