3D Workspace
Home
Assets
Affiliate Program
Sign up/Log in
?
Upgrade
DCC Bridge
Anonymous1773316792
03-12 12:09
Model Name
3d printed pcb enclosure
Tags
props
3d printing
realistic
Prompt
Project: Custom PCB Enclosure for 3D Printing with Wall Mounting Specifications: Board Dimensions: Length: 100mm (10cm) - X axis Width: 90mm (9cm) - Y axis Maximum Height: 35mm (3.5cm) Internal PCB Mounting Holes (4 holes - 3mm diameter each): Top-left hole: 15.114mm from left edge, 15.494mm from top edge Top-right hole: 4.826mm from right edge, 15.494mm from top edge Bottom-left hole: 15.114mm from left edge, 14.478mm from bottom edge Bottom-right hole: 4.826mm from right edge, 14.478mm from bottom edge Add 4mm clearance around each hole for screw heads Internal standoffs: 6mm height, 5mm diameter with 3mm through-holes 10-Pin Connector Cutout (LEFT SIDE): Location: Left side wall of enclosure Vertical position: Starts 18mm from top edge Ends 19mm from bottom edge Total opening height: 53mm (90mm - 18mm - 19mm) Opening width: 18-20mm (for connector access and cable insertion) This is a SIDE WALL CUTOUT extending through the left enclosure wall Wall Mounting Features (EXTERNAL): 4 mounting ears/tabs extending from enclosure exterior Position: Near each corner, outside the main enclosure walls Mounting hole diameter: 4-5mm (for wall screws) Ear dimensions: Approximately 10mm width × 15mm length × 2mm thickness Hole position in ears: Centered, 3mm from outer edge Allow clearance for screw heads (8-10mm diameter counterbore) Alternative: Keyhole slots for easier wall mounting Enclosure Design: Two-part design: Top cover + Bottom base Wall thickness: 2mm (FDM 3D printing compatible) Closure mechanism: Primary: Snap-fit clips (4-6 clips around perimeter) Clip specifications: 2mm width, 1.5mm height, 45° angle for easy assembly/disassembly Alternative/Backup: Small screw holes (2-3mm diameter) if snap-fits not feasible Filleted edges: 2mm radius for printability and aesthetics Manufacturing: Designed for FDM 3D printing (PLA/PETG) Minimize or eliminate support structures Print-ready orientation (bottom base prints flat, top cover prints flat) Tolerance: 0.2-0.3mm for proper fit Layer height: 0.2mm recommended Additional Features: Optional ventilation slots on top cover (if space allows) Smooth internal corners (no sharp edges) Label/engraving area on top surface Cable strain relief near connector opening (optional) Output Format: STL or STEP file (separate files for top cover and bottom base) Assembly Notes: Snap-fit assembly preferred Wall mounting holes should align when enclosure is assembled PCB sits on internal standoffs with 3mm screws from bottom
Detailed Info
Related Models
Enter invite code
Enter invite code to get credits!
Anonymous1773316792
Anonymous1773316792